Steps
1
Place the power adapter port into the slot on the palm-rest and keyboard assembly.
2
Replace the screw (M2x3) that secures the power adapter port to the palm-rest and keyboard assembly.
3
Connect the power adapter cable to the system board and route the cable through the routing guide.
4
Press the right hinge on to the system board, and palm-rest and keyboard assembly.
5
Replace the three screws (M2.5x5) that secure the right hinge to the system board, and palm-rest and keyboard assembly.
Next steps
1
Installing the WLAN.
2
Installing the battery.
3
Installing the
base
cover.
4
Installing the
SD memory
5
Follow the procedure in
Display bezel
Removing the display bezel
Prerequisites
1
Follow the procedure in
2
Removing the
SD memory
3
Removing the
base
cover.
4
Removing the battery.
5
Removing the WLAN.
6
Removing the
display
About this task
The following image indicates the location of the display bezel and provides a visual representation of the removal procedure:
52
Removing and installing components
card.
After working on your thin
Before working on your thin
card.
assembly.
client.
client.