Steps
1
Place the touch pad into the slot on the palm-rest and keyboard assembly.
2
Replace the four screws (M2x2) that secure the touch pad to the palm-rest and keyboard assembly.
3
Adhere the two tapes that secure the touch pad.
4
Adhere the touch pad cable on to the palm-rest and keyboard assembly.
5
Slide the touch pad cable into its connector on the system board and close the latch to secure the cable.
6
Place the touch pad bracket into the slot on the palm-rest and keyboard assembly.
7
Replace the three screws (M2x2) that secure the touch pad bracket to the palm-rest and keyboard assembly.
8
Adhere the tape that secures the bracket to the palm-rest and keyboard assembly.
Next steps
1
Installing the battery.
2
Installing the
base
cover.
3
Installing the
SD memory
4
Follow the procedure in
VGA daughterboard
Removing the VGA daughterboard
Prerequisites
1
Follow the procedure in
2
Removing the
SD memory
3
Removing the
base
cover.
34
Removing and installing components
card.
After working on your thin
Before working on your thin
card.
client.
client.