Installing Display Assembly; Display Bezel - Dell P72S User Manual

Installing display assembly

1. Place the chassis on the edge of a plane surface.
2. Align the display assembly to align with the screw holders on the computer.
3. Tighten the M2*5 screws to secure the display assembly to the computer.
4. Lift the computer and close the display.
5. Connect the display cable and IR camera cable to the connectors on the system board.
6. Place the metal bracket to secure the display cable.
7. Tighten the M2*5 screws to secure the display cable.
8. Route the WLAN cables through the routing channels.
9. Install the:
a. WLAN
b. battery
c. base cover
10. Follow the procedure in

Display bezel

Removing display bezel
The following procedure is applicable only if your computer is a non-touch computer.
1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
c. WLAN
d. display assembly
3. To remove the display bezel:
a. Pry the display bezel at the base of the display [1].
b. Lift the display bezel to release it [2].
c. Pry the edges on the side of the display to release the display bezel [3, 4].
44 Disassembly and reassembly
After working on your thin
Before working on your thin
client.
client.