Table of Contents
Advertisement
Steps
1
Remove the eight screws (six M2.5x2.5 and two M2x2) that secure the display panel to the display back-cover.
2
Lift the display panel and turn it over.
3
Peel the tape that secures the display cable to the back of the display panel.
4
Lift the latch and disconnect the display cable from the display panel cable connector.
5
Lift the display panel away from the display back-cover.
NOTE:
Do not pull and release the Stretch (SR) Tapes from the display panel. There is no need to separate the brackets
from the display panel.
After performing all the preceding steps, you are left with the display panel.
Installing the display panel
Prerequisite
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display panel and provides a visual representation of the installation procedure:
Removing and installing components
57
Hide quick links:
Advertisement
Table of Contents
