Battery Status Led; Diagnostic Led - Dell Wyse 5470 Service Manual

3 On the boot menu screen, select the Diagnostics option.
The Enhanced Pre-boot System Assessment window is displayed.
4 Click the arrow key at the bottom-left corner.
The Diagnostics front page is displayed.
5 Press the arrow in the lower-right corner to go to the page listing.
The detected items are listed.
6 To run a diagnostic test on a specific device, press Esc and click Yes to stop the diagnostic test.
7 Select the device from the left pane, and click Run Tests.
If there are any issues, error codes are displayed. Note the error code and validation number, and contact Dell.

Battery status LED

Table 16. Battery status LED
Power Source
AC Adapter
AC Adapter
AC Adapter
Battery
Battery
Battery
• S0 (ON)—System is turned on.
• S4—The system consumes the least power compared to all other sleep states. The system is almost at an OFF state, expect for a
trickle power. The context data is written to hard drive.
• S5 (OFF)—The system is in a shutdown state.

Diagnostic LED

This section details the diagnostic features of the battery LED.
Instead of beep codes, errors are indicated via the bicolor Battery Charge/Status LED. A specific blink pattern is followed by flashing a
pattern of flashes in amber, followed by white. The pattern then repeats.
NOTE: The diagnostic pattern consists of a two-digit number being represented by a first group of LED blinks (1 through 9) in
amber, followed by a 1.5 second pause with the LED off, and then a second group of LED blinks (1 through 9) in white. This is
then followed by a three second pause, with the LED off, before repeating over again. Each LED blink takes 0.5 seconds.
The system will not shut down when displaying the Diagnostic Error Codes.
Diagnostic Error Codes always supersede any other use of the LED. For instance, on Laptops, battery codes for Low Battery or Battery
Failure situations will not be displayed when Diagnostic Error Codes are being displayed.
Table 17. Diagnostic LED
Blinking pattern
Amber White
2 1
2 2
LED behavior
Solid White
Solid White
Off
Amber
Off
Off
Possible problem
CPU failure
System Board failure (included BIOS corruption or
ROM error)
System Power State
S0
S4/S5
S4/S5
S0
S0
S4/S5
Suggested resolution
Replace the system board
Flash latest BIOS version. If problem persists, replace
the system board
Battery Charge Level
0-100%
< Fully Charged
Fully Charged
< = 10%
> 10%
0-100%
Troubleshooting your system 77