Table of Contents
Advertisement
438 Breakdown assistance
Affix part
1
of the TIREFIT sticker to the
#
instrument cluster within the driver's field of
vision.
Affix part
2
of the TIREFIT sticker near the
#
valve on the wheel with the defective tyre.
Pull plug
4
with the cable and hose
#
of the tyre inflation compressor housing.
Push the plug of hose
#
tyre sealant bottle
1
Place tyre sealant bottle
#
into recess
2
of the tyre inflation compres‐
sor.
Remove the valve cap from valve
#
faulty tyre.
Screw filling hose
8
#
Insert plug
4
into a 12 V socket in your
#
vehicle.
5
out
Switch the ignition on.
#
5
into flange
6
of
Press on and off switch
#
until the plug engages.
tion compressor.
The tyre inflation compressor is switched on.
1
head downwards
The tyre is inflated. First, tyre sealant is pum‐
ped into the tyre. The pressure may briefly
rise to approximately 500 kPa (5 bar/73 psi).
Do not switch off the tyre inflation compres‐
sor during this phase!
Let the tyre inflation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre
pressure of at least 200 kPa (2.0 bar/
29 psi).
If tyre sealant leaks out, make sure you clean the
affected area as quickly as possible. It is prefera‐
7
on the
ble to use clear water.
If you get tyre sealant on your clothing, have it
onto valve 7.
cleaned as soon as possible with perchloroethy‐
lene.
3
on the tyre infla‐
Advertisement
Table of Contents
