Status Display - GE AF-600 FP Operating Instructions Manual

AF-600 FP High Power Operating Instructions
The display is divided into 3 sections:
Top section (a) shows the status when in status mode or up to 2 variables when not in status mode and in the case of Alarm/Warning.
The number of the Active Set-up (selected as the Active Set-up in par. K-10 Active Set-up) is shown. When programming in another Set-up than the Active Set-up,
the number of the Set-up being programmed appears to the right in brackets.
The Middle section (b) shows up to 5 variables with related unit, regardless of status. In case of alarm/warning, the warning is shown instead of the variables.
It is possible to toggle between three status read-out displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The values / measurements to be displayed can be defined via par.
K-20 Display Line 1.1 Small, par. K-21 Display Line 1.2 Small, par. K-22 Display Line 1.3 Small, par. K-23 Display Line 2 Large, and par. K-24 Display Line 3 Large,
which can be accessed via Main Menu then Keypad Setup.
6
Each value / measurement readout parameter selected in par. K-20 Display Line 1.1 Small to par. K-24 Display Line 3 Large has its own scale and number of digits
after a possible decimal point. Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
Status display I:
This read-out state is standard after start-up or initialization.
Use [INFO] to obtain information about the value/measurement linked to the
displayed operating variables (1.1, 1.2, 1.3, 2, and 3).
1.1
See the operating variables shown in the display in this illustration. 1.1, 1.2
and 1.3 are shown in small size. 2 and 3 are shown in medium size.
1.2
2
3
1.3
Status display II:
See the operating variables (1.1, 1.2, 1.3, and 2) shown in the display in this
illustration.
In the example, Speed, Motor current, Motor power and Frequency are se-
lected as variables in the first and second lines.
1.1, 1.2 and 1.3 are shown in small size. 2 is shown in large size.
72