Installation Method - icetro SSI-300T User Manual

Installation method

SSI-300
Electrical connection
●
- Consult with the engineers of the company for the details of installation of the system to ensure optimal
performance of the system (change of the installation site of the system also requires consultation with
the engineer of the company).
- Do not install the system on a place with adverse conditions such as uneven floor, place exposed to direct
light, or place with too much dusts or direct splashing of water.
1. Connect the main power for single-phase
power distribution box.
Install an earth leakage breaker (with capacity of
30A or higher) in the distribution box.
◆ Earth shall be provided for the safe operation of the system.
◆ Maintain space of 50cm or more each between
the walls and the right and rear sides, 20cm or more
between the left of the system.
◆ Precisely seat the rubber feet at the bottom to
prevent slipping
2. Remove the screws of the left side cover
and remove the cover of the inside control
box by the same method.
3. Plug in the power cord and measure voltage at the ends of
two power cords (L, N) of termnal block.
4. Measure the phase voltages.
They should match the voltage displayed in
'1-3'. If not, then using a straight headed
driver, adjust the PCB variable resistancel
ocated in the control box at the bottom front
of the product as shown in the figure on the right.
Measurement must be taken by a qualified electrician and adjust voltage to values displayed in '1-3'.
For your
Otherwise, icecream will be too waterly or too thick.
infromatoon
side cover
control box cover
L
N
9