For Long-Term Storage - icetro SSI-300T User Manual

For long-term storage

●
The machine will be out of order if water gets frozen due to sub-zero temperature in winter.
Be sure to drain water before storing the machine.
●
The manufacturer will not be responsible for the freezing and bursting of the machine without
Waring
draining water. Be sure to keep the following precautions to avoid charging of excessive
repair cost:
1. Drain raw ice cream liquid, clean the machine, and assemble the dasher cover and dasher
assay while the body is still wet from cleaning.
(Refer to the user instruction for the cleaning method.)
2. Lock the water supply valve. The power supply must be connected at this point, so check if it is.
3. Disconnect the water supply valve from the side of
the machine to drain any remaining water in
the line. (Figure 1)
4. Unscrew the quick valve cover from the lower part
of the left panel and have a basket ready at the
outlet hose.
(The basket is for collecting the water that may spill
on the ground.)
5. Turn and open the quick valve inside of the valve
cover counter-clockwise.
This will allow the water to flow from the outlet hose.
(Figure 2)
6. Press the "AUTO" button and keep the machine
running for 5~10 minutes.
(Up to 10 minutes until the high-pressure switch is activated and
the machine stops.)
7. Press the "STOP" button on the front to stop the machine.
8. After water is completely drained, lock the water valve (Figure 1)
and quick valve (Figure 2) and close the cover.
(About 1.3~1.5 liters of water will be drained.)
9. To reuse the machine, lock the quick valve again (Figure 2) and reconnect the water
supply line (Figure 2)
● Be sure to check the following when connecting the water supply line!
1 . T he pi p e m us t hav e a diamet er bigger t han Φ 1 2.7 mm.
2 . Ch e c k i f t h e pr es s ure is between 0. 3 and 0. 5 Mpa o n the w at er pres su re ga uge a ft er
c on n ec t i n g t he line. (The wat er pres s ure gauge is o n t he b ac k o f th e m ach in e. )
3 . I f p r es s u r e is lower t han 0.3 Mpa when operat i ng t he ma chi ne , co ntro l th e flo w of
th e m ain v alv e t o ens ure s t able operat ion.
4 . T he hi g h - p r es s ure c ut -out s wit c h (HPS) of t he ma ch in e w il l be ac ti va te d t o st op an d
pr o t ec t th e m ac hine unless pres s ure is s trong e no ug h.
Re me m b er to maint ain t he proper w at er pres s ure .
12
drain hose
valve cover
water bottle
(Figure 1)
quick valve
(Figure 2)
water pipe
off
separation
open
close