Jog Function - gefran ADV200 Manual

9 – JOG FUNCTION
Menu PAR Description
9.1 910 Jog setpoint
The reference for Jog mode operation. This reference can also be set via an analog input. The Jog reference
is enabled when the signal used for the Jog + or Jog – command is enabled, the Run command is not present
and the drive output frequency is zero.
Menu PAR Description
9.2 912 Jog acceleration
9.3 914 Jog deceleration
Setting of the acceleration/deceleration ramp time (in seconds) used during Jog operation.
Menu PAR Description
9.4 916 Jog cmd + src
Selection of the origin (source) of the Jog + function enabling signal. When this command is enabled it gener-
ates a Jog Mode reference with a sign matching the value entered for the Jog setpoint value parameter. The
signal to be associated with this function can be selected from the "L_DIGSEL2" selection list.
Note !
The Run command has priority over the Jog + command.
Menu PAR Description
9.5 918 Jog cmd - src
Selection of the origin (source) of the Jog - function enabling signal. When this command is enabled the Jog
Mode reference sign is inverted with respect to the value entered in the Jog setpoint value parameter. The
signal to be associated with this function can be selected from the "L_DIGSEL2" selection list.
Note ! The Run command has priority over the Jog - command.
Menu PAR Description
9.6 920 Jog output mon
The speed reference used by the Jog command is displayed.
ADV200 • Functions description and parameters list
UM Type FB BIT
rpm INT16
UM Type FB BIT
s FLOAT
s FLOAT
UM Type FB BIT
LINK 16
UM Type FB BIT
LINK 16
UM Type FB BIT
rpm INT16 16/32
Def Min
0 CALCI
Def Min
5.0 0.01
5.0 0.01
Def Min
6000 0
Def Min
6000 0
Def Min
0 0
Max Acc Mod
CALCI RW FVS
Max Acc Mod
1000.00 RW FVS
1000.00 RW FVS
Max Acc Mod
16384 RW FVS
Max Acc Mod
16384 RW FVS
Max Acc Mod
0 ER FVS
43