Antenna Types; Rfu-E Antenna Types - Cambium Networks PTP 820 RFU-E Installation Manual

Chapter 1: Before You Start

Antenna Types

RFU-E Antenna Types

RFU-E uses two types of antennas:
•
Integrated 43 dBi Class 3 antenna
•
Direct Mount antenna.
RFU-E Integrated Antenna
The following table describes the electrical parameters of the RFU-E integrated antenna.
Table 1: RFU-E Integrated Antenna – Electrical Parameters
Frequency coverage
Gain
3dB beam width (azimuth and elevation)
Polarization
Co/cross-polar ratio
Side lobe suppression
Direct Mount Antenna
RFU-E can be mounted directly using the following antenna types (for integrated antennas, specific antennas are
required):
•
CommScope: VHLP series
The Direct Mount antenna interface is according to:
Waveguide Standard
WR12
If a different antenna type (CPR flange) is used, a flange adaptor is required. Please contact your Cambium
Networks representative for details.
Note
Appropriate lubricant or grease can be applied to the screws that connect the RFU-E to the antenna
interface.
71-86 GHz
43dBi
1°
Single Linear, V or H
>30dB
ETSI EN 3020217-4 V2.1.1 (2017-05) | CLASS 3
phn-4026 003v000
Page 1-7
Antenna Flange
UG387/U
Antenna Types