Table of Contents
Advertisement
5
Quick start
The STM32G4 Nucleo-64 board is a low-cost and easy-to-use development kit, used to evaluate and start a
development quickly with an STM32G4 Series microcontroller in LQFP64 package. Before installing and using the
product, accept the Evaluation Product License Agreement from the
information on the STM32G4 Nucleo-64 and for demonstration software, visit the
webpage.
5.1
Getting started
Follow the sequence below to configure the STM32G4 Nucleo-64 board and launch the demonstration application
(refer to
Figure 4
1.
Check the jumper position on the board (refer to
2.
For the correct identification of the device interfaces from the host PC and before connecting the board,
install the Nucleo USB driver available on the
3.
To power the board, connect the STM32G4 Nucleo-64 board to a PC with a USB cable (Type-A to Micro-B)
through the USB connector CN1 of the board
4.
Then, green LED LD3 (5V_PWR) and red LED LD1 (COM) light up, green LED LD2 (USER) blinks
5.
Press user button B1 (left blue USER button)
6.
Observe how the blinking of the green LED LD2 changes according to the clicks on button B1
7.
The software demonstration and the several software examples that allow users exercise Nucleo features,
are available on the
8.
Develop your own application using the available examples
Jumper
JP1
JP3
JP5
JP6
JP7
JP8
1. Default jumper state is shown in bold.
UM2505 - Rev 2
for component location):
www.st.com/stm32nucleo
Table 4.
Definition
NRST
T_RST
5 V power-source selection
IDD
BOOT0
VREF+ selection (VREF or VDD
voltage supply selection)
www.st.com/epla
Table
4)
www.st.com/stm32nucleo
website
webpage
Jumper configuration
(1)
Position
OFF
ON
ON [1-2] (Default)
ON [3-4] (optional)
ON [5-6] (optional)
ON [7-8] (optional)
ON
OFF
ON [1-2] (Default)
ON [2-3] (optional)
UM2505
Quick start
webpage. For more
www.st.com/stm32nucleo
(1)
Comment
STLINK-V3E reset
-
5V_USB_STLK (from ST-LINK)
5V_VIN
E5V
5V_USB_CHGR
VREF+ supplied with VREF
VREF+ supplied with VDD
page 6/43
Advertisement
Table of Contents
Need help?
Do you have a question about the STM32G4 Nucleo-64 and is the answer not in the manual?