Quick Start; Getting Started; Default Board Configuration; Table 4. Default Jumper Configuration - ST STM32H5 User Manual

5

Quick start

The STM32H5 Nucleo-64 board is a low-cost and easy-to-use development kit, to evaluate and start development
quickly with an STM32H5 series microcontroller in an LQFP 64-pin package.
Before installing and using the product, accept the Evaluation Product License Agreement from the
epla webpage. For more information on the STM32H5 Nucleo-64 board and demonstration software, visit the
www.st.com/stm32nucleo
5.1

Getting started

Follow the sequence below to configure the STM32H5 Nucleo-64 board and launch the demonstration application
(refer to Figure 5
1. Check the jumper position on the board (refer to
2. Power the board by connecting the STM32H5 Nucleo-64 board to a PC with a USB cable (USB Type-A to
USB Type-C
3. Then, the 5V_PWR green (LD3), the COM (LD1), and the PWR (LD7) LEDs light up, and the user green
LED (LD2) blinks.
4. Press the user blue button (B1).
5. Observe how the blinking of the green LED (LD2) changes according to the clicks on the button (B1).
6. The demonstration software and several software examples that allow exercising Nucleo features are
available on the
7. Develop your application using the available examples.
5.2

Default board configuration

The default jumper configuration and voltage settings are shown in
Jumper
JP1
JP2
JP5
JP6
UM3121 - Rev 1
webpage.
for component location):
® ®
or USB Type-C to USB Type-C
www.st.com website.
Table 4.
Definition
ST-LINK reset
IDD measurement
5 V power source selection
VDD
Figure 3).
®
) through the USB connector (CN1) of the board.
Table 4.
Default jumper configuration
Position
OFF
ON
[1-2]
ON
UM3121
Quick start
www.st.com/
Comment
STLINK-V3EC MCU is not under Reset
mode
VDD_MCU current measurement
5 V from STLINK-V3EC (5V_STLK)
VDD supplied with 3V3
page 6/37