Installation
3 Installation
3.1 Mounting
The converter can be mounted to a wall, a
pipe or directly to a control valve as illustrat-
ed in the dimension diagrams on
page 14.
The device is delivered with a stainless steel
bracket for wall mounting.
The following mounting accessories are re-
quired depending on the type of mounting to
be used:
− Pipe mounting, order no. 1400-6216
− Attachment to a valve with cast yoke,
order no. 1400-6217
− Attachment to a valve with rod-type
yoke, order no. 1400-6218
Mounting position
The converter is to be installed horizontally,
with the pressure gauge (or screw plug) fac-
ing upward.
If a different mounting position is used for
the 4 to 20 mA version with switch-off elec-
tronics, the zero point must be readjusted as
described in section 4.
With degree of protection IP 54, the connec-
tion for the vent plug must always be in-
stalled facing downward to the floor.
8
EB 6126 EN