Table of Contents
Advertisement
0
22
Chapter 4 Shooting : Shooting
7
Upload a mission.
Check each item.
Connected: GNSS connection status
Once a sufficient number of GNSS are
connected, the GNSS icon appears.
Range: GNSS and controller signal strength
: Controller battery level
: Drone battery level
: Drone and Map Pilot for DJI - Business
app connection status
Swipe left on
, and tap [Upload].
ˎ
When the geographical confirmation
message appears, tap [No].
Mission upload begins.
ˎ
When the flight path confirmation
message appears, tap [OK].
ˎ
When the move home point confirmation
message appears, tap [OK].
The home point moves to the location
where the GNSS signal is being received.
8
Press the sensor unit shutter button.
The status indicator flashes alternating
between green and red and shooting begins.
The status indicator turns solid red when the
drone is ready to launch.
[Caution]
ˎ After pressing the sensor unit shutter button, take
ˎ
care not to move the sensor unit.
ˎ The sensor unit and camera shutter button are
ˎ
synchronized. Note that if you press the camera
shutter button after pressing the sensor unit shutter
button, shooting ends.
9
After the status indicator turns red, wait
approximately 20 seconds and tap [Start] to
begin the mission.
[Notes]
The wait time of approximately 20 seconds is required
to accurately calculate the ground elevation.
The drone takes off.
Ending shooting
When the mission is complete and the drone
returns to the home point, shooting ends.
[Caution]
Make sure to follow the steps below to end shooting. If
the camera and sensor unit power are on, take care not to
accidentally disconnect the connecting cable or mobile
battery cable.
1
When the mission complete message appears,
tap [OK].
Advertisement
Table of Contents
