Selecting The Check Program; Configure Compartment Fine Positioning - Leuze electronic LSIS 472i Series Operating Instructions Manual

NOTICE
Configuration changes only in the
 Changes made using the
mode.
9.3.3

Selecting the check program

There is a check program stored on the device for the detection of both the
positions.
CONFIGURATION > PROGRAMS
 Select
Overview of Check Programs
The
Overview of Check Programs
Figure 9.3:
 Select the check program that you would like to activate (
Table 9.1:
Digital input IO2
0
1
0
1
9.3.4

Configure compartment fine positioning

To commission more quickly, you can set the most important parameters for the check programs (
Near Rack Far
and
Alternatively, you can make the configuration settings for compartment fine positioning manually; see
chapter 9.3.6.
The configuration for compartment fine positioning for faster commissioning is only available if
the device is directly connected to the PC/laptop.
Leuze electronic
Service
CONFIGURATION
dialog is displayed.
Overview of digital inputs for check programs
Digital input IO3
0
0
1
1
) via a configuration dialog.
Extended configuration – Leuze electronic webConfig tool
operating mode!
function can only be performed in the
.
Rack Near
Selection ID
0
1
2
3
LSIS 472i
Service
operating
Rack Near Rack Far
and
Rack Far
or ).
Check program
Rack Near
Rack Far
Not defined
Not defined
hole
Rack
32