Leuze electronic LSIS 472i Series Operating Instructions Manual page 13

• Device type
SW:
• Software version
HW:
• Hardware version
SN:
• Serial number
• Status displays
• Status display of the switching inputs/outputs
• Display of warnings and errors
• Status information for the device interfaces
• Target/actual position deviation for X- and Y-coordinates in mm
• Statistics
Statistics data for the smart camera:
Tested
•
Number of check program runs since the last time the counter was reset
OK
•
Number of successful check program runs
NOK
•
Number of unsuccessful check program runs
• Position display of the marking (hole or reflector)
1
1
Figure 3.4: Position display
• Parameter
Parameter handling
•
Lock and enable parameter entry on the display
Define password for enabling parameter entry
Reset parameters to factory settings
Display settings
•
Rotate the display 180°
Only possible with enabled parameter entry
Program selection
•
Activation of the check program via the display for compartment fine positioning:
Rack Far
Ethernet
•
Configuration of the host and service interface
• Language
Selection of the language used in the display:
German, English, Spanish, French, Italian
• Service
Status messages
•
Only for service purposes by Leuze electronic
Commissioning
•
Selection of the check program and position display for alignment; see chapter 8 "Commissioning"
Teaching-in of the position (teach); see chapter 8.3 "Teaching-in the position"
In Service mode, the device is decoupled from Process mode. Triggering via the switching inputs
is not possible and the digital switching outputs are not set.
Leuze electronic
Actual position of the marking within the capture range
LSIS 472i
Device description
Rack Near
or
13