Notice Before Use; Product Structure - German pool RHS 6328 User Manual

Notice Before Use

Important
For safety purpose, you should read the instructions carefully before using the appliance for the first
time. Save the instructions for future reference.
The appliance is designed for domestic use and may only be installed and operated in accordance with
these instructions for use.
1. The appliance is not intended for the use of, and playing with, by persons (including children) with
reduced physical, sensory or mental capabilities, or any individual lack of experience and knowledge,
unless they have been given supervision or instruction.
2. Keep children away from the appliance. Do not let them use the appliance without supervision.
3. If the power supply cord is damaged, do not operate the appliance. Contact German Pool or a
licensed technician for a replacement immediately.
4. Disconnect the power supply before cleaning, repairing or dismantling the range hood.
5. The range hood must be earthed.
6. Connect the range hood with an independent air vent to exhaust lampblack.
7. The air must not be discharged into a venting pipe that is used for exhausting fumes from appliances
burning gas or other fuels.
8. The connection opening at the top of the range hood must be connected to the exhaust pipe for
exhausting fumes to the outdoors. Exhaust pipe of 6 inches in diameter should be used.
9. The appliance should be positioned 700±50mm above the cooking range.
10. Do not flambe under the range hood.
11. Please wear safety gloves for installation, cleaning, light bulb changing and dismantling in order to
prevent injuries.
12. To protect electrical parts, do not splash or spray the range hood with water.
13. German Pool range hood has high venting efficiency. Most of the grease vapor will be exhausted
through the air vent when the range hood is in operation. Only very little amount of residual oil will be
collected in the Oil Collecting Tray.
14. There should be adequate ventilation in the room when the range hood is used along with appli-
ances that burn gas or other fuels.
15. Regulations concerning the discharge of air have to be fulfilled.
16. To prevent fire hazard in case of oil build-up, the easily-soiled parts must be cleaned at least once
a week.
P.4

Product Structure

9 3 4
1. Motor cover
2. Body
3. LED Light
4. Control panel
5. Rectification plate (oil collector inside)
6. Main power switch
7. Cut-of f switch
8. Thermo-sense auto star t device
9. Infrared-sense auto star t device
1
8 5 7 2 6
P.5