Care & Maintenance - German pool RHS 6328 User Manual

Operation Instructions
III. Infrared-Sense Auto Start
-Under stand-by status, when on object close to infrared sensor, the fan will activate at high speed for
60 seconds.
IV. Thermo-Sense Auto Start
Note: Make sure the range hood is at stand-by status thus thermo-sense auto start can operate.
-When the gas cooking range is working without the fan turned on, and the air temperature under
the range hood reaches 55-60°C (130-140°F), thermal sensor will activate the fan to run at medium
speed for 45 seconds.
-If the temperature under the range hood still reaches 55-60°C (130-140°F) after the auto start has
completed, the fan will be activated again as described in the step above.
Note:
After the first activation of auto start, you need to press the desired Fan speed H-M-L if you want keep
the fan running.
V. Cut-Off Switch
-The range hood is set up a micro switch (position shown as P.5- NO.7)
a. When the rectification plate is opened, the power of range hood will be cut off.
b. When the rectification plate is closed, the power of range hood will be connected.
P.10
Care & Maintenance
Important
-To ensure the most optimum efficiency, the range hood must be cleaned at least once a week.
-Make sure to wear safety gloves before cleaning or dismantling the metal parts of the range hood in
order to reduce the risk of any injury caused by the sharp edges.
-Warning: There is a risk of fire if repair and cleaning of the range hood (especially the fan and other
easily-soiled parts) are not carried out in accordance with the instructions.
1. Power plug must be disconnected before cleaning and repair.
2. Use soft cloth with mild detergent to clean the surface of the hood from outside and inside each
time after use and then clean with a cloth soaked with water. Avoid scraping the surface.
3. Clear oil from oil collectors when they are more than half full of grease in order to avoid spilling.
Open rectification plate, pull and slide the oil collector placed under the fan. Wash and wrap it dry.
Then slide and push it back.
4. When open the rectification plate the limited switch will cut off the power.
5. Move the rectification plate to avoid of any damage incurred, if the rectification plate dropped.
6. Hold both sides of the rectification plate and pulls upwards to release the rectification plate.
Phillips screw driver
(4) ( ) 5 ( ) 6
P.11