KYMCO Downtown 125i 2009 Service Manual page 218

Cortesia de/ Courtesy of: www.batmotos.com
16. REAR BRAKE/REAR FORK/REAR
WHEEL/REAR SHOCK ABSORBER
INSTALLATION
Install the brake caliper to the rear fork and
tighten the two bolts.
Torque: 27 N-m
Connect the brake fluid tube to the brake caliper
and install fluid tube bolt, copper washers and
tighten the fluid tube bolt.
Fill the brake reservoir with the specified brake
fluid and bleed air from the brake system.
＊
When installing the brake fluid tube, be sure
to install the two copper sealing washers.
REAR FORK
REMOVAL
Remove the exhaust muffler.
Remove the rear brake caliper.
Remove the right rear shock absorber lower
mount bolt.
Remove the rear axle nut and remove the collar.
Remove the rear fork.
The installation sequence is the reverse of
removal.
Turn the inner race of each bearing with your
finger to see if they turn smoothly and quietly.
Also check if the outer race fits tightly in the hub.
Replace the bearings if the races do not turn
smoothly, quietly, or if they fit loosely in the hub.
Cortesia de/ Courtesy of: www.batmotos.com
Fluid Tube Bolt
Bolts
Rear Axle Nut
Bolt
Collar
DOWNTOWN 125 i
Brake Caliper
Rear Brake Caliper
Bolts
16-6