KYMCO Downtown 125i 2009 Service Manual page 179

Cortesia de/ Courtesy of: www.batmotos.com
14.
DOWNTOWN 125 i FUEL SYSTEM (Auto Control Fuel Injection System)
CELP Failure Code Chart(3)
Blink Failure
Codes
11 P0350
12 P0230
13 P0219
14 P1560
15 P0700
16 P0115
17 P1561
14-9
Cortesia de/ Courtesy of: www.batmotos.com
Fault description
Ignition coil or electric
circuit malfunction
Fuel pump relay or electric
circuit malfunction
Engine speed is over than
top speed
Sensor don't receive power
source from ECU
Engine starting speed
exceed CVT speed limited
Engine temperature sensor or
electric circuit malfunction
Temperature gauge electric
circuit malfunction
Priority
1. Check if the connector of ignition coil is loosen.
2
2. Check if the ECU send signal to Ignition coil.
3. Check if the power source and resistance is malfunction.
2 1. Check if the connector of relay is loosen.
2. Check if the ECU send signal to relay.
3.
Check the fuel pump relay resistance
2 Check if the belt of CVT is broken.
2 1. Check if ECU output DC5V to sensor.
2. Check if the power source of all sensor is DC5V.
3. Replace a new ECU if the CELP still blinks even the output power
source of ECU is normal.
2 1. Check if the throttle wire locked.
2. Check if the position of throttle screw is correct.
3. Check if the belt of CVT is broken.
2 1. Check if the connector of sensor is loosen.
2. Check if ECU pin is broken.
3.Check if the resistance of sensor is malfunction.
2 Don't use it at present.
Fault management