Setting A Welcome Message; Operation; Introduction; Lcd Display - EuroLite DMX Scan Control 192 MK2 User Manual

Setting a Welcome Message

7. OPERATION

Introduction

With the controller you can control up to twelve devices with up to 16 DMX channels per device. 30 banks
with each eight programmable scenes are available as program memory. You can program six chases, each
with up to 240 programmed scenes. Control is done via eight faders and further function buttons. You can
very easily control pan and tilt of a scanner using the joystick.

LCD Display

The display indicates 2 x 8 characters with the following functions:
Display (example)
CHASE5
STEP002
DATA168
WT:1M36S
TP:5.32S
FT:10.5S
ASS 07 08
RES 10 13
SN6
BK 03
1. Switch off the device.
2. Simultaneously press SCANNER 6 and 12 and turn the device on
again. After 2 seconds, the LEDs of SCANNER 6 and 12 will be on.
The controller is now ready for setting a message.
3. Press SCANNER 6 and 12 to move the cursor on the display.
4. Press BANK UP/DOWN to select the desired character.
5. Repeat step 3 and 4 to set further characters.
6. Simultaneously press SCANNER 6 and 12 to memorize your setting.
To confirm the memory procedure, all LEDs of the controller flash
three times and the device reboots.
Function
Chase 5 is activated
Second step of a chase
DMX value (000-255)
The current waiting time is 1 minute and 36 seconds
The time interval between the last two Tap keystrokes
is 5.32 seconds
The fade time is 10.5 seconds
Assign DMX channels 7 and 8
Reverse DMX channels 10 and 13
Scene 6
Bank 03
39/56 00116794, Version 1.0