Configuration; Adjusting The Dmx Starting Addresses Of The Lighting Effect Units; Assigning Pan/Tilt To Control Elements - EuroLite DMX Scan Control 192 MK2 User Manual

6. CONFIGURATION

Adjusting the DMX Starting Addresses of the Lighting Effect Units

Adjust the DMX starting address of the connected light effect units according to the following scheme. If
identical units are to be controlled synchronously, they can receive the same starting address; otherwise
each unit must receive an individual address. For further information, please refer to the unit's
documentation.
Unit Button
1 SCANNER 1
2 SCANNER 2
3 SCANNER 3
4 SCANNER 4
5 SCANNER 5
6 SCANNER 6
7 SCANNER 7
8 SCANNER 8
9 SCANNER 9
10 SCANNER 10
11 SCANNER 11
12 SCANNER 12
Table 6.1 Default values for the starting address of the light effect units

Assigning Pan/Tilt to Control Elements

Channel Starting
group address
A 001
B
009
A
017
B
025
A
033
B
041
A
049
B
057
A
065
B
073
A 081
B
089
A
097
B
105
A
113
B
121
A
129
B
137
A
145
B
153
A 161
B
169
A
177
B
185
1. Enable programming mode.
2. Press FINE and MODE twice simultaneously. Then the LED ASSIGN lights
up and indicates that the assign mode is active.
3. With BANK UP/DOWN you can switch between Pan and Tilt. The
corresponding LED indicates your selection.
35/56 00116794, Version 1.0