C - Manual Temperature Programming - Sanremo Opera Instructions Manual

OPERA
5.13.b - "Water dose" manual program-
ming(Fig. 19)
• Position a container under spout (1).
• Press button (2) on the first unit on the left for 10
seconds, until its LED flashes (3).
• Within 30 seconds, press button (4) to dispense hot
water, when the desired quantity is reached, press
button (4) again to stop dispensing.
The dispensed quantity is stored in memory.

5.13.c - Manual temperature programming.

Cup heating plate temperature (Fig. 20).
• Programming the temperature of the cup heating
plate is possible only using the first unit on the left.
• On the first group on the left press the button (1)
EN
and keep it pressed, at the same time move forward
the lever (2) and through the buttons (3) and (4) it's
possible to enable "ON" or disable "OFF" the cup
heating plate heating; press the button (1) to confirm.
The cup heating plate status is shown in field "A" of
the group's display.
• If enabled the cup heating plate heating, in the field
"A" of the display appears an "ON" writing and is
shown the "050 CUP ON" writing too (50% cup
heating power).
• Press the button (3) to descrease power, on the other
hand press (4) to increase it.
• To confirm the set data press the button (1) .
Operation of the machine
2
A
14 / 24
CAP. 5
Fig. 19
4
3
Fig. 20
B
2
4
3
1
06-2017
1