Advertisement
SECTION II
INSTALLATION
2.1
UNPACKING AND INSPECTION
. .
It is recommended that. the shipping carton containing the RA 7 690/GM HF Receiver be
.
examined for damage before the Receiver is unpacked. If damage
to
the carton is observable. trY
to have the carrier's agent present when the equipment is unpacked. If this
is
not possible, retain
the shipping cartons and padding material for the carrier's inspection if damage to the equipment
is evident after unpacking.
.'
No special unloading equipment is required, except to handle the carton with normal
care given to any shipping carton containing electronic equipment. Figures 2-1 and 2-2 show the
critical dimensions and packaging details associated with the RA6790/GM HF Receiver. To unpack
the Receiver, the following procedure should be observed.
1. Carefully open the top of the shipping carton and fold back the flaps.
2. Lift out the top foam cushion.
3. Carefully lift out the wrapped Receiver.
4. Remove the wrapping from thel Receiver.
5. Carefully lift out the Receiver.
6. Place the Receiver on a convenient work bench.
7. Replace all packaging material back in the shipping carton. Save all material in the
event that the Receiver must be reshipped.
See that the equipment is complete as listed on the packing slip. Contact your RACAL
representative or RACAL Communications, Inc., Rockville, Maryland with details of any shortage.
The unit was thoroughly inspected and factory adjusted for optimum performance prior
to shipment. It is, therefore, ready for use upon receipt. After uncrating and checking contents
against the packing slip, visually inspect all exterior surfaces for dents and scratches. If external
damage is visible, remove the dust covers and inspect the internal components for apparent damage.
Then check the internal cables for loose connections, and plug-in items which may have been
loosened from their receptacles.
'.
2.2
PREPARATION FOR RESIDPMENT AND STORAGE
If the RA6790/GM must be prepared for reshipment, the packaging methods should follow
the pattern established in the original shipment. If retained, the original materials can be used to a
large extent or will at a minimum provide guidance for the repackaging effort. The Receiver must
be disconnected and removed from its mounting rack before being prepared for reshipment. The
following procedures describe the recommended sequence.
2-1
Advertisement
