Connecting A Recorder Signal To An Output Device - Hach AquaTrend 51200 Instrument Manual

4.1.4 Connecting a Recorder Signal to an Output Device

51350-18 Alarms Relays Recorders.fm
7. A screen showing all of your selections will appear. Select DETACH
ALARM FROM RELAY and press enter to confirm the setting or select
CANCEL then press ENTER to exit without making changes.
The message CONFIGURING NETWORK...PLEASE WAIT, followed by
OPERATION COMPLETE will appear when the alarm has been detached.
The output device must be properly configured before attempting to configure
the sensor's recorder signals. Refer to the Signal Output Module Instruction
Manual for more information.
1. Press the MENU key to access the Main Menu.
2. Select Network Menu and press ENTER.
3. Select RECORDER TO ANALOG OUT and press ENTER.
4. Select ATTACH and press ENTER.
If only one sensor is available for relay attachment, go to step 5 .
•
• If two or more sensors are found on the network, the AquaTrend
Interface will present a list of sensors from which to choose. Select
the sensor of interest and press ENTER
• If two or more recorders are available, a menu showing
available recorders will appear. Select the recorder of interest
and press ENTER.
• If two or more Signal Output Modules are available, select the SOM of
interest and press ENTER.
5. Select RECORDER 1 or RECORDER 2 and press ENTER.
Section 4
Page 45
Alarm to Relay Connections