Attaching A Measurement To A Channel; Detaching A Measurement From A Channel - Hach AquaTrend 51200 Instrument Manual

Section 3

3.4.4 Attaching a Measurement to a Channel

3.4.5 Detaching a Measurement from a Channel

Page 30
Network Setup
Although sensors may have been added to the network, readings will not be
displayed until a measurement is attached to a channel. AquaTrend Interface
sensors can report one or more measurements, depending on the type of
sensor. Attach each sensor measurement to one of the eight AquaTrend
Interface channels when setting up a new sensor.
1. Press the MENU key to begin at the Main Menu.
2. Use the up or down arrow key to select the AquaTrend Menu and
press ENTER.
3. Select DISPLAY SETUP and press ENTER.
4. Select MEASUREMENT TO CHANNEL and press ENTER.
5. Select ATTACH, and press ENTER. A list of available sensors will appear.
6. Select the sensor of interest and press ENTER.
7. Select the channel of interest and press ENTER.
• If the sensor has more than one measurement available, select the
desired measurement and press ENTER.
8. Select ATTACH and press ENTER to continue, or select Cancel to cancel
the attachment.
The message OPERATION COMPLETE will appear. The screen will return to
the display setup menu upon completion of the measurement to channel
setup. To see the data display, press the DISPLAY key.
Proceed as follows to detach a measurement from a channel:
1. Press the MENU key to begin at the Main Menu.
2. Use the up or down arrow key to select the AquaTrend Menu and
press ENTER.
3. Select DISPLAY SETUP and press ENTER.
51350-18 Initial Aquatrend Setup.fm