Recalibration - Siemens SITRANS F Series Operating Instructions Manual

Service and maintenance

9.3 Recalibration

Use of a computer in a hazardous area
If the interface to the computer is used in the hazardous area, there is a risk of explosion.
● Ensure that the atmosphere is explosion-free (hot work permit).
Releasing button lock
Improper modification of parameters could influence process safety.
● Make sure that only authorized personnel may cancel the button locking of devices for
NOTICE
Penetration of moisture into the device
Device damage.
● Make sure when carrying out cleaning and maintenance work that no moisture penetrates
Impermissible repair of explosion protected devices
Risk of explosion in hazardous areas
● Repair must be carried out by Siemens authorized personnel only.
9.3 Recalibration
Siemens A/S, Flow Instruments offers to recalibrate the sensor at our works in Denmark. The
following calibration types are offered as standard according to configuration:
● Standard calibration
● Density calibration
Note
SensorFlash
For sensor recalibration the SensorFlash memory unit must always be returned with the
sensor.
98
WARNING
CAUTION
safety-related applications.
the inside of the device.
WARNING
FC310 (From firmware 4.0)
Operating Instructions, 06/2018, A5E44036384-AA