Installing A Module - Siemens SIMATIC NET RUGGEDCOM RSG2100 Service Manual

2.3.2

Installing a Module

To install a module, do the following:
Note
Some modules require a heat sink and/or gap pads. To determine if your module re-
quires these pieces, refer to
Installing a Module (With Heatsink)
To install a module into slot 1-4 or 7-10 that requires a heat sink, do the following:
1.
2.
RUGGEDCOM RSG2100
Service Manual, 07/2019, C79000-G8976-1151
If the module is to be installed on the underside of the main inner assembly, flip
the board.
Slide the module into the faceplate and align it with the connector in the main
inner assembly.
Figure 2.20 Inserting the Module
"Module Overview (Page
Module Replacement
2.3.2 Installing a Module
5)".
27