Table of Contents
Advertisement
3.7.5
Installing a Baby Board ADSL module
Installation Procedures
Step
1.
Select the SLIMC module. The Baby Board is a Modem for ADSL over POTS and
will not support ADSL over ISDN (an external Modem must be used in case of ADSL
over ISDN).
2.
Attach the separators provided with the module.
3.
Attach the Baby Board ADSL module to the separators.
4.
Connect the cable of the Ethernet Interface to the X6 Connectors.
5.
Connect the cable of the ADSL line to the X14 Connectors.
6.
Connect the power cable of the module Baby Board ADSL to the X7 Connectors.
7.
"Performing a visual inspection" on page 3-35.
8.
Configure the required data (see Service Manual).
Assembly Diagram
Figure 3-7
Installing a Baby Board ADSL module HiPath 1120
HiPath1120, Installation Guide
Procedure
X14
X6
X7
Baby Board ADSL Modul
(for ADSL over POTS only)
X14
X6
X7
Installation
Installing modules
3-21
Advertisement
Table of Contents
