RUGGEDCOM RX1512
Installation Guide
Removing a Module
To remove a line module, do the following:
1.
[Optional] If the device is installed in a rack, remove it from the rack.
2.
Loosen the screws that secure the module.
3.
Pull the module from the chassis to disconnect it.
Figure 14: Removing a Module
1. Module 2. Chassis 3. Screw
4.
Install a new module or a blank module (to prevent the ingress of dust and dirt).
5.
[Optional] If necessary, install the device in the rack.
Installing a Module
To install a line module, do the following:
1.
[Optional] If the device is installed in a rack, remove it from the rack.
2.
Remove the current module from the slot.
3.
Insert the new module into the slot.
Installing/Removing Line Modules
1
2
3
Chapter 4
Modules
27