2D Goniometer SmartLead User Manual
6 Pre-Use Check
6.1 Normal Appearance of Signals
The sensor's STATUS LED provides a means of communicating its operational state. In the idle
state, the STATUS LED will flash blue at a low, once per second rate. When the sensor is actively
measuring a signal, the STATUS LED will flash recognizably faster (green).
Please review the application diagrams in Appendix B for on the body placement information of the
2D Goniometer sensor for specific joints.
Quick Testing:
To ensure that the 2D Goniometer SmartLead is measuring properly when connected to the Ultium
Sensor, move the two sensors (green endblocks) relative to each other to displace the angle slightly.
You should notice a change in the signal showing angular displacement in MR3.
15
(Rev D January 2020)