F1 -Cal; F2 100G - Adam Equipment WBZ Series Service Manual

F6 init
F7 rE
F8 SCSivE
F9 Ad
F10 round
F11 ZEro
F12 Lvd
F13 CAL
F14 ACLr
F15 Cal

8.2.1 F1 -CAL

To advance to the next parameter, press the [0] key or to enter the calibration parameter
press the [Tare] key when "
The display will instruct you to remove any weight from the scale, "
The display will tell you to add weight to the scale: "
Add the weight shown, wait for stability then press the [Tare] key.
The display will show "
calibration could not be completed correctly.
The display will then show "
gain access. Remove the weight. Switch off the scale and switch it on to continue with
the other Service parameters.
8.2.2 F2 –100G
To enter this parameter, press the [Tare] key when "
The display will show "
© Adam Equipment Company 2008
ZEro
Initial Zero Range
ZEro
Re-Zero range
tArE
Successive Tare Enable
Count
Display the A/D counts
Rounding off the Total Price
Select the zero mode
mod
Low voltage detection
batt
Set calibration of battery voltage measurements
Not active,
Cnt
Enable or disable the Calibration Counting function
F1 CAL
" is displayed.
SPAn PASS
" " " if the calibration is OK. Or it will show "
JP on
" indicating the jumper is still in place if it was used to
PriCE on
" " " or "
LoAd
" "

F2 100G

PriCE oFF
" " " .
14
UnLoAd
". Press [Tare].
6 kiloS
" " "
SPAn
" is shown.
FAIL
" " " if