F11 -Zero; F12 -Low Voltage Detection - Adam Equipment WBZ Series Service Manual

F11 –ZERO
8.2.11
This parameter allows the normal method of setting zero or a slightly different method
required for Sri Lanka to be used.
To enter this parameter, press the [Tare] key when "
The display will show the current settings, "
modE 1
" " is to be selected at all times unless the scale is intended for Sri Lanka.
Press the [0] key to change the value.
Press [Tare] to accept the displayed value and return to the parameter.
Press the [0] key to advance to the next parameter.
F12 –LOW VOLTAGE DETECTION
8.2.12
This parameter allows detection of low voltage when the battery wears down.
To enter this parameter, press the [Tare] key when "
The display will show if the LVD Mode is set to on or off.
Press the [0] key to change the value.
Press [Tare] to accept the displayed value and return to the parameter.
Press the [0] key to advance to the next parameter.
NOTE: Only the "on" option is allowed for the WBZ scales. Set to off only for testing or to
allow operation before the battery voltage calibration is completed.
© Adam Equipment Company 2008
F11
" is shown.
modE 1 modE 2
" or "
F12
" is shown.
19
".