Using "2006" To Enter The Service Parameters - Adam Equipment WBZ Series Service Manual

Or, " SPA n" "
" JP On
8.2

USING "2006" TO ENTER THE SERVICE PARAMETERS

After the jumper has been placed at J1 on pins 1 &2, apply power to the scale or use the
Calibration Count method as described in section 7.3 to access the passcode display if the
Counting method has been enabled.
Display will ask for a code number, "
Enter the number 2006 when "
The displays will show the first parameters, called "
press the [0] key to advance through the parameters.
Press the [Tare] key to enter a parameter.
To exit a parameter, press the [
The Weight Display window will show the parameter number and the Unit Price window
will show the word describing the function.
When a parameter is entered by pressing the [Tare] key, the displays will guide you
through the parameter selected and the options available.
The parameters available are:
F1 CAL
F2 100g
F3 Unit
F4 CAPA
F5 Point
© Adam Equipment Company 2008
This means calibration has failed. Remove
FA L "
i
the calibration weight and repeat the
process.
This is shown only if a jumper was used to
"
gain access. Switch off the scale. Remove
the jumper. Switch on the scale for normal
weighing.
Pn
Pn
" is displayed and then press [Tare].
Z  ] key.  
To enter the Calibration
Enable price per 100g or per kg option
Select kilograms or pounds
Select capacity
Unit Price/Price decimal point
" on the Unit Price window.
F1 CAL
" "
13
". To select another parameter