Honeywell Spyder 5 User Manual page 49

SPYDER MODEL 5 ENGINEERING TOOL – USER GUIDE
Modifications and Consistency Check
Whenever working on the application, e.g. periodic program, on board I/O etc., every modification is detected by the
control manager and indicated graphically by a yellow warning symbol that replaces the original symbols at the modified
item on the wire sheet, and in the tree. This applies to teaching mode ´on demand` only. When working in teaching
mode ´immediate`, changes are not indicated graphically since they are written instantly to the controller.
Example:
In addition, the IRM Program icon and the component´s icon gets a dark square background .
The control manager icon switches from synchronous state to non-synchronous state ..
On the property sheet of the controller manager, the synchronization status switches accordingly:
Fig. 3. Synchronization Status Information in Control Manager before Application Change
Fig. 4. Synchronization Status Information in Control Manager after Application Change
Depending on where the application is created (project) or changed (project or controller), the application must be
taught to the controller, or must be learned from the controller to achieve synchronicity. In both cases, if meaningful and
required, the controller or the project must be cleared before.
49 31-00282ES-01