Honeywell Spyder 5 User Manual page 27

Matching Devices ", p. 28).
6. Teach the application to the controller. If there is an application already running in the controller, clear the controller
7. Finally perform the hardware compatibility check to make sure that the application is properly designed for running
seamlessly in the created device.
8. If software recommends, remove function blocks in the control logic.
NOTE: Add the physical IO points. Make sure to select the right physical point template that matches the online
device model.
NOTE: It is allowed matching smaller offline device models with bigger online device models. It is strongly
recommended not match devices vice versa, since hardware compatibility issues may arise. In this case, please
execute the hardware compatibility check and rework the application accordingly. Or, install a bigger device with
more hardware I/Os at the site.
For further information on offline engineering, please refer also to the "Factory Device Handling" section, p. 37.
SPYDER MODEL 5 ENGINEERING TOOL – USER GUIDE
27 31-00282ES-01