Setting The Beep And Announcement Level - Icom IC-F29SR2 Operating Manual

4
SETTINGS

Setting the beep and announcement level

You can adjust the beep and announcement level
between 1 and 5, or 1 (linked) and 5 (linked). When
a linked option is selected, the beep audio level is
adjustable by rotating [VOL].
NOTE: Turn ON the Beep function before you start
setting the beep and announcement level. (p. 6)
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [ROTARY SELECTOR] to any channel other
than Channel 16.
3. While holding down [Lower], rotate [VOL] to turn
ON the transceiver and enter the Beep Level
Adjustment mode.
• An opening beep sounds and the selected channel
number is announced.
4. Push [Upper] to change the beep level.
• A beep sounds every time you push [Upper].
Therefore, you can determine the current level setting
by the increasing loudness of the beep that sounds.
Information
L
• The adjustable range is 1 ~ 5, or 1 (Linked) ~ 5
(Linked).
•  R epeatedlypushing[Upper]firstselects1(lowest)to
5 (highest), and then selects the lowest linked level, 1
(Linked) to the highest, 5 (Linked).
Repeatedly pushing [Upper] repeats the cycle. See the
illustration to the right.
• To determine if you have selected a linked level, set
[VOL] to minimum, then push [Upper] repeatedly,
listening for the loudest beep (level 5). Pushing
[Upper] once after the loudest beep will select 1
(Linked). Repeatedly push [Upper] to select the
desired linked level.
5. Rotate [VOL] to turn OFF the transceiver and exit
the Beep Level Adjustment mode.
[ROTARY SELECTOR]
[Upper]
[Lower]
7
[VOL]
Pushing
[Upper]
5
4
3
2
1
5 (Linked)
4 (Linked)
3 (Linked)
2 (Linked)
1 (Linked)