Table of Contents
Advertisement
5. Objective
Screw off the dust cover on the converter, screw the
objective into the trapped hole
The objectives should match the lettering on the
converter by their magnification.
Screw the dust cover into other vacancies.
6. Sample platform
Assemble the platform 135X85R/L
with the mainframe by three bolt
M4X10
★The platform can be assembled
at either right or left.(meanwhile
the X/Y hand wheel can be at
either right or left)
★The transmitted support can be
tilt a bit to the back to assemble the
platform.
Put the section bracket close to the spring on the edge of the platform and
press it to the platform levelly.
Spring
Dust cover
Install bolt
Section bracket
Pic. 9
Objective
Pic. 7
Platform
Transmitted illumination support
X/Y hand wheel
Pic. 8
Advertisement
Table of Contents
