2.2.4
Installing a host/expansion board
IMPORTANT! Ensure that you installed at least four (4) 3.5-inch hard drives in bays 1-4 if you want to
install a host/expansion board.
NOTES:
•
•
To install a host/expansion board:
1.
Shut down your system.
2.
Facing the rear panel, remove the two screws that secure the host/expansion board's dummy cover
to the system.
EonStor GSe Pro 100 Series Hardware Manual
A downtime may occur when you install or replace the host/expansion board.
To add or replace a host board, the firmware automatically restores the default factory settings of
your system.
2-7