2.2.4
Installing the host boards
NOTES:
•
•
To install a host board:
1.
Shut down your system.
2.
On the controller that you want to add a host board, unfasten the retention screw located under the
ejection levers.
Mounting hole
3.
Push down the ejection levers to dislodge the controller from the system (A), then pull to remove
from the enclosure (B).
EonStor GSa 3000 Series Hardware Manual
A downtime may occur when upgrading the controller/host board.
To add or replace a host board, the firmware automatically restores the default factory settings of
your system.
Ejection lever
Ejection lever
Mounting hole
2-11