Noraxon Ultium EMG User Manual page 12

Analog Output
With the Analog Output Module properly connected (see Component Interconnections above), the
data collected in MR3 will be automatically sent to the third part data acquisition unit that is
connected via a 25-pin male to female cable (Part #291D). Each module allows for the
transmission of up to 16 channels. For instructions as to which pins correspond to which channel,
view the bottom of the Analog Output Module.
If your applications call for more than 16 analog signals, two Analog Output Modules may be used.
In which case, a total of 32 signals can be sent through the analog output terminals at once. The
numbers given to the channels in the configuration (see image below) correspond to the order in
which data is sent through the Analog Output Module.
P-881 Rev B (May 2019)
8