Selecting Frequency - Lectrosonics SMWB Quick Start Manual

4) Use the
green and the –20 dB LED starts to flicker red during the loudest peaks
in the audio.
5) Once the audio gain has been set, the signal can be sent through the
sound system for overall level adjustments, monitor settings, etc.
6) If the audio output level of the receiver is too high or low, use only the
controls on the receiver to make adjustments. Always leave the trans-
mitter gain adjustment set according to these instructions, and do not
change it to adjust the audio output level of the receiver.

Selecting Frequency

The setup screen for frequency selection offers several ways to browse the
available frequencies.
Gain
Freq
Rolloff
Compat
Each field will step through the available frequencies in a different increment.
The increments are also different in the 25 kHz mode from the 100 kHz mode.
Freq.
b 19
51
494.500
Freq.
b 19
51
494.500
Freq.
b 19
51
494.500
12
arrow buttons to adjust the gain until the –10 dB glows
and
Freq.
b
494.500
These two fields step in 25 kHz
increments when the step size is 25
kHz and 100 kHz increments when
the step size is 100 kHz.
These two fields
always step in the
same increments
1 block steps
1 MHz steps
Press MENU/
19
SEL to select
one of four
51
fields to make
adjustments
Freq.
494.500
LECTROSONICS, INC.
b 19
51