Table of Contents
Advertisement
Location and Function of Parts
Remote Controller
Upper section
1 STDBY button
2 LIVE/MEMORY button
3 MEMORY +/– buttons
4 FOCUS FAR/NEAR
buttons
5 Release button
1 STDBY (standby) button
When using a lens other than the special-purpose lens
(VCL-1205BYS), pressing this button puts the camera
into the standby mode, and stops down the iris to the
current setting.
2 LIVE/MEMORY button
Pressing this button toggles between the live and
memory monitor modes.
Live mode: The image from the camera lens is
output to the monitor. At this point the lens iris is
automatically in the fully-open position.
Memory mode: The image saved in the currently
selected memory is output to the monitor.
16
Chapter 1 Overview
STDBY
USER
IRIS
+
LIVE/MEMORY E-ZOOM
--
MEMORY FOCUS
ZOOM
+
T
FAR
--
W
NEAR
6 USER button
7 E-ZOOM button
8 IRIS +/– buttons
9 ZOOM T/W buttons
Hang the loop of string on the
tripod or some other safe place.
3 MEMORY +/– buttons
In the memory monitor mode, these buttons select the
memory.
MEMORY +: Pressing this button switches from the
currently selected memory to the next higher
numbered memory (1 n 2 n 3 ... ).
MEMORY –: Pressing this button switches from the
currently selected memory to the next lower
numbered memory (9 n 8 n 7 ... ).
4 FOCUS FAR/NEAR buttons
These adjust the focus.
FOCUS FAR: Pressing this button focuses further
away.
FOCUS NEAR: Pressing this button focuses closer
to the camera.
Note
The remote controller has a
slot in the back, through
which you can thread a loop
of string.
Advertisement
Table of Contents
