Sony DKC-ST5 Operating Instructions Manual page 14

Location and Function of Parts
Rear panel
1 MODE SELECT switches
These eight DIP switches select the SCSI ID of the
digital processor, the attenuation compensation setting
for the camera cable, and other settings.
For details of the settings of these switches, see the section
"Setting the DIP Switches" on page 50.
2 SCSI In and SCSI Out connectors (50-pin, high-
density)
Use these to connect to other SCSI devices (computer,
printer, and so forth).
For details of the SCSI connections, see the section "SCSI
Connections" on page 48.
3 FLASH connector (X-contact socket)
Connect the cable from a flash unit.
This connector is not used when the cable from the
flash unit is connected to the FLASH connector on the
camera head.
14
Chapter 1 Overview
1 MODE SELECT switches
2 SCSI In and SCSI Out connectors
3 FLASH connector
FLASH
SCSI
SCSI In
MODE SELECT
SCSI Out
MONITOR
VIDEO S-VIDEO
R G B SYNC
FS
7 REMOTE FS connector
8 MONITOR connectors
4 ⁄ AC IN connector
⁄
AC IN
REMOTE CAMERA
RS-232C
5 CAMERA connector
6 REMOTE RS-232C connector
4 ⁄ AC IN connector
Use the supplied power cord to connect to a 120 V AC
(NTSC model) or 220 to 240 V AC (PAL model)
power outlet.
5 CAMERA connector (26-pin, female)
Connect this to the PROCESSOR connector of the
camera head with the supplied camera cable.
6 REMOTE RS-232C connector (D-sub 9-pin,
female)
(Undefined.)
7 REMOTE FS (foot switch) connector (mini-
jack)
Connect the cable from a foot switch.