Sony DKC-ST5 Operating Instructions Manual page 49

SCSI ID
Not using the DKC-ST5 internal terminator
In this case, carry out the two following items:
• Disable the DKC-ST5 internal terminator. (Set DIP switch 4 on the
digital processor to the OFF position; see the next page.)
• Fit an external terminator to the last SCSI device in the chain. It is
recommended to use an active type of external terminator.
SCSI In
connector
DKC-ST5
Computer
Disable internal
terminator
UP-D8800
Computer
Note
The number of operative terminators in a SCSI chain must always be two.
When you connect a number of SCSI devices in a daisy-chain, it is
important to assign SCSI IDs (0 to 7) to the devices in such a way that they
do not conflict.
To set the SCSI ID of the DKC-ST5, use DIP switches 6 to 8 on the digital
processor.
For details of the settings of the DIP switches, see the next page.
Note that the allocation of IDs is not related to the physical sequence of the
devices in the chain.
SCSI Out
connector
UP-D8800
Fit external terminator
to last SCSI device in
the chain.
SCSI In connector SCSI Out connector
DKC-ST5
Disable internal terminator and
fit external terminator.
Chapter 3 Installation and Connections
Terminator
Terminator
49