Sony DKC-ST5 Operating Instructions Manual page 47

Attaching Ferrite Cores to Cables
How to open the ferrite cores
Use a screwdriver to
unlock the latches.
Type-A ferrite core
Type A
SCSI cable
a) When placing the ferrite core on the cable, make one turn of cable
through the core.
b) To connect a foot switch cable to the PAL model of DKC-ST5, use a
Type-B ferrite core. When placing the ferrite core on the cable, make
one turn of cable through the core.
c) With the PAL model of DKC-ST5, place two Type-C ferrite cores on
the camera cable, one at the processor-side end of cable and the
other at the camera-side end.
To protect the digital processor against noise which may affect its
operation, attach supplied ferrite cores (noise filters) to some of the
connection cables as shown below.
Type-B ferrite core
SCSI FLASH
SCSI In
MODE SELECT
SCSI Out
MONITOR
VIDEO S-VIDEO
R G B SYNC
Type B
S-video Foot switch
a) b)
cable cable
Type-C ferrite core (for PAL model only)
⁄ AC IN
REMOTE CAMERA
RS-232C
FS
Type C
Camera
c)
cable
9-pin remote
Type C
control cable
To the camera
Chapter 3 Installation and Connections
Type A
Power cord
47