Table of Contents
Advertisement
Location and Function of Parts
Rear view
1 VF (viewfinder) connector (DIN 8-pin)
Connect the cable from the viewfinder.
2 MONITOR connector (BNC type)
This outputs a composite video signal. Using a
75-ohm coaxial cable (not supplied), connect this to
the composite video input connector (BNC type) of a
video monitor.
3 FLASH connector (X-contact socket)
Connect the cable from a flash unit.
This connector is not used when the cable from the
flash unit is connected to the FLASH connector on the
digital processor.
12
Chapter 1 Overview
1 VF connector
VF
MONITOR
FLASH
PROCESSOR
LENS1
REMOTE
6 PROCESSOR connector
4 REMOTE connector (12-pin, female)
Connect the supplied remote controller.
5 LENS1 connector (20-pin, female)
When using the special-purpose lens (VCL-1205BYS),
connect the cable from the lens.
6 PROCESSOR connector (26-pin, male)
Connect this to the CAMERA connector of the digital
processor with the supplied camera cable.
2 MONITOR connector
3 FLASH connector
4 REMOTE connector
5 LENS1 connector
Advertisement
Table of Contents
