Sony DKC-ST5 Operating Instructions Manual page 36

Shooting
36
Chapter 2 Operation
4
Press the release button.
This instantaneously stops the lens down to the iris setting, and
captures an image to the selected memory.
Note
When using a lens other than the special-purpose lens
(VCL-1205BYS), press the STDBY button first, to switch to the
standby mode, then press the release button.
When you switch to standby mode, after about 3 seconds the iris is
stopped down to the current setting, and the "STAND-BY" mode
indication appears on the monitor screen.
• When the memory selection mode is "increment on," first the system
switches to review mode, and the image captured to memory appears
on the monitor for a few seconds.
Next the system switches back to live monitor mode. During the
review, the "REVIEW" mode indication appears on the monitor
screen.
• When the memory selection mode is "increment off," the system
switches to memory monitor mode, and the image captured to
memory is displayed on the monitor screen.
For details of the memory selection mode, see the section "Selecting a
Memory" on the next page.
5
To continue shooting, repeat steps 2 to 4.