Error Messages - Sony DKC-ST5 Operating Instructions Manual

Error Messages

Message
BB:NG Please try again
COMMANDER IS LOCKED
FLASH CALIBRATION: NG
MEMORY FULL
MEMORY IS LOCKED
Not available during transferring image
data
Not available except AWB setting as C-
Temp
Not available in E-ZOOM mode
WB:NG Please try again
If the system is unable to operate normally because of a particular
combination of operations, an error message may appear on the monitor.
The following table lists the error messages, with their meanings and
appropriate action to take.
Meaning
Black balance adjustment failed.
The remote controller has been locked
by the computer.
Flash calibration failed.
The memory for captured images is full.
The currently selected memory for
captured images is locked (write-
protected).
This operation is not possible during
image data transfer.
This operation is not possible unless the
"C-TEMP" menu item is set to "AWB."
This operation is not possible in the
electronic zoom mode.
White balance adjustment failed.
Action to take
Check the conditions, and try again.
Unlock the remote controller from the
computer.
Check the condition of the flash, subject
and so forth, and try again.
Delete images no longer required from
memory.
Either unlock this memory, or select a
different memory.
Wait until image data transfer is
finished.
Set the "C-TEMP" menu item to "AWB."
Exit from the electronic zoom mode and
retry.
Check the conditions, and try again.
Chapter 6 Maintenance
63